Alliance/Encore L4-1721cc 105 CID (1985)
17.
Connect the coolant temperature, TPS, idle speed motor, MAT and MAP sensor, and the WOT switch connectors.
18.
Install the distributor cap.
19.
Clean the bolt threads in the crankshaft and the threads of the crankshaft pulley bolt.
20.
Install the pulley on the crankshaft.
21.
Apply two drops of Loctite 271 to the crankshaft pulley bolt threads and install the bolt. Tighten the bolt to 95 N-m (70 ft.lbs.) torque.
22.
Tighten the A/C compressor mounting bracket bolts to 38 N-m (928 ft.lbs.) torque.
23.
Install and adjust the accessory drive belt as outlined in the August 1986, edition of the M.R. 245 manual.
CAUTION: The belt must be installed as described in the manual. An incorrectly installed belt can turn the water pump in the wrong direction resulting
in overheating.
24.
Install the splash shield in the front passenger side wheel well.
25.
Raise the vehicle, connect the exhaust pipes and lower the vehicle.
26.
Install the air cleaner and fill and bleed the cooling system.
Parts, SRT & Filing Information
PARTS INFORMATION
DESCRIPTION
QUANTITY
PART NUMBER
SEALS, Valve Stem
8
7700 737 124
SRT INFORMATION
OPERATION
OPERATION DESCRIPTION
NUMBER
TIME
TIC
CO. CYLINDER HEAD-R&R
1069
3.0
1-180
SO. VALVE STEM SEALS-REPLACE
0114
1.4
1-180
Filing Instructions
Record this I.S. Note on page B-49 of M.R. 245 and file it in the manual.