Fuego L4-2165cc 2.2L (1984)
Altitude Compensator: Technical Service Bulletins
Engine - Altitude Performance Adjustments
13E108
DECEMBER 1983
1984 RENAULT ALLIANCE/ ENCORE/FUEGO TURBO MODELS
ENGINE
Attention: Workshop, Parts Department.
ALTITUDE PERFORMANCE ADJUSTMENTS
Information
This I.S Note outlines adjustments for optimum performance on 1984 Renault Alliance, Encore, and Fuego Turbo models being operated at high or low
altitudes.
NOTE:
The California Fuego Turbo 136A model is the only 1984 Renault vehicle requiring altitude adjustment. 1984 Alliance, Encore, and 49-State
Fuego Turbo models do not require adjustment. The electronic control systems on these models have built-in compensating circuits that make
necessary adjustments automatically.
When necessary, perform the engine adjustments outlined in the Adjustment Procedures portion of this I.S. Note. In addition, any California Renault
Fuego Turbo that is so adjusted must have a unique Emission Control Information Update label installed. The part numbers for these unique labels are
provided in the following Adjustment Procedures.
The adjustment procedures and unique labels must be made available at no cost to independent repair facilities and the general public. A notification is
also provided in current owner's manuals to make customers aware of these adjustments. The Emission Control Information Update labels and technical
information are available through the Milwaukee National Parts Distribution Center.
ADJUSTMENT PROCEDURES
California Renault Fuego Turbo 136A Models
On California only 136A models originally sold for operation at altitudes below 4,000 feet that are being operated at altitudes above 4,000 feet, addition
of an altitude compensating resistor connector board to the fuel injection circuit is the only adjustment required.
RESISTOR CONNECTOR BOARD INSTALLATION
1.
Remove the side panel from the passenger side of the console.
2.
Remove the protective sheath from the connector (see illustration).
3.
Install resistor connector board, part number 7701 028 536 in the fuel injection harness connector and install the sheath over the
