renault Workshop Repair Guides

Renault Workshop Service and Repair Manuals

Paint - Maintaining Stone Chip Protection|Page 885 > < Paint - Maintaining Stone Chip Protection|Page 883
Page 2
background image

3.

DEPROTECTION PRECAUTIONS

-

Do not deprotect the vehicle without wearing rubber gloves and safety glasses. The deprotection solution could cause irritation if the eyes or skin
are exposed. If irritation should occur, flush the affected area thoroughly with water and consult a physician if irritation persists.

-

Be sure the deprotection area is well ventilated.

-

Do not allow the protective film to remain on any new vehicle for more than six (6) months.

-

Never use the gel concentrate full strength.

-

Do not deprotect the vehicle indirect sunlight or apply the deprotection solution to a hot surface.

-

Do not attempt deprotection in temperatures below 32~F.

-

Be sure the vehicle doors and windows are tightly shut.

-

Cover the windshield and rear window moulding joint clips with tape to prevent deprotection solution from collecting under the mouldings.

-

Be sure the vehicle body is dry before applying the first coating of deprotection solution.

4.

DEPROTECTION PROCEDURE

1.

Fill the portable sprayer with deprotection solution consisting of one (1) part deprotection gel concentrate and six (6) parts water.

CAUTION: Do not use the gel concentrate full strength on any surface.

2.

Close the vehicle doors and windows. Move the windshield wiper arms/blades away from the windshield. Remove any protective adhesive paper
from exterior body components. Cover the joint clips on the windshield and rear window mouldings with masking tape to keep the deprotection
solution from getting under the mouldings.

3.

Dry the vehicle with a low pressure stream of compressed air if wet. Do not use a cloth to remove moisture as any dust particles trapped in the
protective film might scratch the paint.

4.

Spray the deprotection solution over the entire vehicle. Start with the roof followed by the hood and trunk surfaces. When applying solution to
vertical surfaces (doors, fenders, etc.), work from top to bottom.

CAUTION: Do not apply the deprotection solution to a hot surface or in direct sunlight nor in temperatures below 32~F.

Paint - Maintaining Stone Chip Protection|Page 885 > < Paint - Maintaining Stone Chip Protection|Page 883