R5-Lecar L4-1397cc 1.4L (1983)
FIGURE 12
Installation
1.
Clean the seal bore thoroughly with a lint-free cloth and clean refrigerant oil. Dry the bore with compressed air.
2.
Install seal sleeve protector J-29640 over the compressor shaft (Fig. 12).
CAUTION: Do not touch the new seal lapping surfaces.
3.
Dip the mating surfaces of the seal lapping surfaces in clean refrigerant oil.
4.
Engage the slots of tool J-29639 in seal slots and install the seal firmly into place in the seal bore. Twist the tool in the opposite direction to
disengage it from the seal.
CAUTION: When installing the shaft seal O-Ring, do not scratch the O-Ring groove with the O-ring hook.
5.
Coat the O-ring with clean refrigerant oil and carefully place it in the seal groove with the O-ring hook.
6.
Coat the seal retainer with clean refrigerant oil and install it with tool J-9393-2. Press the retainer lightly against the seal.
7.
Install the snap ring with the beveled edge away from the compressor.
NOTE:
It may be necessary to tap the snap ring lightly to seal it.
8.
Install clutch spacer shims. Tap new felt ring into place and install compressor shaft key.
9.
Install the clutch plate on the shaft and align the plate keyway with the compressor shaft key.
FIGURE 7
