R5-Lecar L4-1397cc 1.4L (1983)
Turn Signal Flasher: Technical Service Bulletins
Turn Signal - New Flasher
28E212
MAY 1984
LE CAR
ELECTRICAL
Attention: Workshop, Parts Department
NEW TURN SIGNAL FLASHER Information
A new type, 4-terminal flasher (P/N 7701 621 732) is now the only flasher available for service replacement use on Le Car vehicles. The 3-terminal
flasher previously used has been discontinued.
When installing the new type flasher, the center, negative (-) terminal must be grounded so that the flasher is compatible with the existing turn signal
circuit. The grounding procedure is outlined below.
Procedure
1.
Fabricate a ground wire for the flasher negative (-) terminal as follows.
a.
Attach male terminal connector 925 062, or equivalent, to one end of a 12-inch length of number 14 or 16 gauge wire.
b.
Insert the terminal connector into the center terminal in the flasher wire harness connector (refer to the illustration).
2.
Connect the flasher wire harness connector to the flasher and install the flasher.
3.
Attach the other end of the flasher ground wire to a convenient vehicle ground with an appropriate size eyelet connector. Shorten or reroute the
ground wire as necessary to avoid interference and to maintain a neat appearance.
4.
Verify that the flasher operates normally.
Parts
Description
Quantity
Part Number
TERMINAL CONNECTOR
1
925 062
FLASHER (4-TERMINAL)
1
7701 621 732
Filing Instructions
Record this I.S. Note in your M.R. 177 manual on page C-32 and file it in your M.R. 177 binder.