9-2X F4-2.0L Turbo (2005)
Remove the lock pin sleeve and boot from caliper body.
Remove the guide pin boot.
ASSEMBLY
14 INCH TYPE
Clean the caliper body interior using brake fluid.
Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
Insert the piston into cylinder.
Important: Do not force piston into cylinder.
Apply a coat of specified grease to the boot and fit in groove on ends of cylinder and piston.
Grease: NIGLUBE RX-2 (Part No. 32005002)
Install the piston boot to caliper body, and then attach boot ring.
(1) Piston boot
(2) Boot ring
(3) Piston seal
(4) Caliper body
Apply a coat of specified grease to the guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 32005002)
