9-2X F4-2.0L Turbo (2005)
Brake Hose/Line: Service and Repair
Brake Hose
Brake Hose
REMOVAL
FRONT BRAKE HOSE
Separate the brake pipe from brake hose.
(Always use the flare nut wrench and be careful not to deform the flare nut.)
Pull out the clamp to remove brake hose.
Remove the bolt at strut and union bolt.
(1) Brake hose
(2) Brake pipe
REAR BRAKE HOSE
Separate the brake pipe from brake hose.
Note: Always use the flare nut wrench and be careful not to deform the flare nut.
Remove the clamp and union bolt.
(1) Brake pipe
(2) Brake hose
(3) Brake hose clamp
INSTALLATION
FRONT BRAKE HOSE
Secure the brake hose to strut.
Tightening torque: 32 Nm (3.3 kgf-m, 23.6 ft. lbs.)
Install the brake hose to caliper using a new gasket.
Tightening torque (Union bolt): 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
