9-2X F4-2.0L Turbo (2005)
Remove the shoe return spring from parking brake assembly.
Remove the front shoe hold-down spring and pin with pliers.
Remove the strut and strut spring.
Remove the adjuster assembly from parking brake assembly.
Remove the brake shoe.
Remove the rear shoe hold-down spring and pin with pliers.
Remove the parking brake cable from parking brake lever.
(1) Parking brake cable
(2) Parking brake lever
Using a standard screwdriver, raise the retainer. Remove the parking brake lever and washer from brake shoe.
INSTALLATION
Important: Be sure the lining surface is free from oil and grease contamination.
Apply brake grease to the following places.
Brake grease: Brake Grease (Part No. 32005008)
^
Six contact surfaces of shoe rim and back plate packing
^
Contact surface of shoe wave and anchor pin
^
Contact surface of lever and strut
^
Contact surface of shoe wave and adjuster assembly
^
Contact surface of shoe wave and strut
^
Contact surface of lever and shoe wave
Insert the primary side brake shoe into anchor pin groove.
Secure the brake shoe with shoe hold-down pin and cup.
Install the plate to anchor pin, and then assemble the primary return spring to anchor pin.
