9-2X F4-2.0L Turbo (2005)
18. Similarly, remove the camshafts (RH) and related parts.
Installation
1. Camshaft installation
Apply engine oil to the cylinder head at camshaft bearing installing location before installing the camshaft. Install the camshaft so that each valve
is close to or in contact with "base circle" of cam lobe.
NOTE:
^
When the camshafts are positioned as shown in the figure, camshaft (LH) needs to be rotated at a minimum to align with the timing belt
during installation.
^
Camshaft (RH) need not be rotated when set at the position shown in the figure.
Intake camshaft (LH): Rotate 80° clockwise.
Exhaust camshaft (LH): Rotate 45° counterclockwise.
2. Camshaft cap and oil flow control solenoid valve assembly installation
a. Apply small amount of liquid gasket to the cap mating surface.
NOTE: Do not apply liquid gasket excessively. Otherwise, the excessive liquid gasket may come out and flow toward oil seal, resulting in oil
leaks.
Liquid gasket. THREE BOND 1215 (Part No. 004403007) or equivalent
b. Apply engine oil to the cap bearing surface, and install the cap on camshaft as shown by identification mark.
c. Gradually tighten the camshaft cap and oil control valve assembly in at least two stages in alphabetical sequence shown in the figure, and then
