9-2X F4-2.0L Turbo (2005)
tighten to specified torque.
Tightening torque:
T1: 9.75 Nm (1.0 kgf-m, 7.2 ft. lbs.)
T2: 20 Nm (2.0 kgf-m, 14.8 ft. lbs.)
d. After tightening the camshaft cap, ensure the camshaft rotates only slightly while holding it at "base" circle.
3. Apply engine oil to the outer perimeter and lips of oil seal, and install the oil seal on camshaft using ST1 and ST2.
NOTE: Use a new oil seal.
ST1 499587600 OIL SEAL GUIDE
ST2 499597200 OIL SEAL GUIDE
4. Rocker cover installation
a. Install the gasket on rocker cover. Install the peripheral gasket and ignition coil gasket.
b. Apply liquid gasket to the designated point of cylinder head.
NOTE: Apply liquid gasket to the half moon plug portion with sticking out more than 5 mm (0.2 inch).
Liquid gasket. THREE BOND 1215 (Part No. 004403007) or equivalent