9-2X F4-2.0L Turbo (2005)
Clutch Switch: Service and Repair
Clutch Switch
REMOVAL
Disconnect the ground cable from battery.
Remove the instrument panel lower cover.
Disconnect the connector from clutch switch.
Remove the clutch switch.
INSTALLATION
CLUTCH SWITCH (CRUISE CONTROL)
Move the clevis pin of the push rod right and left and hold where it moves smoothly, then measure stroke of clutch pedal.
Specified clutch pedal full stroke A: 130 - 135 mm (5.12 - 5.31 inch)
Tightening torque:
T: 8 Nm (0.8 kgf-m, 5.9 ft. lbs.)
If the clutch pedal stroke is out of specification, adjust the stroke.
Connect clutch switch connector.
CLUTCH SWITCH (STARTER INTERLOCK)
Fully depress the clutch pedal.
Install the clutch pedal plate and clutch pedal so that the gap between them is 3 - 3.5 mm (0.12 - 0.14 inch), and then tighten the lock nut.
Tightening torque: 8 Nm (0.8 kgf-m, 5.9 ft. lbs.)
(A) Plate
(B) Clutch pedal
(C) 3 - 3.5 mm (0. 12 - 0.14 inch)
Connect the clutch switch connector.
Confirm that the engine does not start when the clutch pedal is released.
Confirm that the engine starts when the clutch pedal is fully depressed.
INSPECTION
If the clutch switch (cruise control) does not operate properly (or if it does not stop at the specified position), replace with a new one.
Specified position L: 2+1.5/0 mm (0.079 +0.059/0 inch)
