9-2X F4-2.0L Turbo (2005)
HYDRAULIC PRESSURE
Note:
^
Be sure to complete all items aforementioned in "INSPECTION", prior to measuring hydraulic pressure. Otherwise, pressure can not be measured
correctly.
^
Do not leave the valve of pressure gauge closed or hold the steering wheel at stop end for 5 seconds or more in any case, as the oil pump may be
damaged due to long keep of these conditions.
^
Put a cotton cloth waste at a place where fluid drops before the pressure gauge is installed. Wipe off split fluid thoroughly after the measurement.
REGULAR PRESSURE MEASUREMENT
Connect the ST1, ST2 and ST3.
ST7 32005189 PRESSURE GAUGE
ST2 32005042 ADAPTER HOSE B
ST3 32005041 ADAPTER HOSE A
Remove the air intake duct.
Disconnect the pipe C from the pump.
Using the gasket (Part No. 32006872) and bolt (Part No. 32006871), install the ST2 to the pump instead of pipe C.
Install the ST3 to end of pipe C removed from pump.
Replenish power steering fluid to the specified level.
Open the valve. and start the engine.
Measure the regular pressure.
Service limit: 981 kPa (10 kg/cm2, 142 psi) or less
If it is not within the specified value, replace the troubled part caused by the following symptoms; pipe or hose clogged, leaks from fluid line, and mix
of foreign objects in fluid line.
Measure the relief pressure.
Using the STs, measure the relief pressure.
Close the valve.
