9-2X F4-2.0L Turbo (2005)
Attach the steering body to ST as shown in the figure. Apply a coat of grease to needle bearing.
ST 32005190 STAND
Important: Ensure the needle bearing is free from defects. If it is faulty, replace the steering body with a new one.
Using the ST-13 and ST-C, attach the oil seal to ST.A.
ST 32009463 INSTALLER A, B, C
Note: Face the oil seal in direction shown in the figure.
Insert the ST-A with oil seal assembled, through gear side of rack. Remove the oil seal from ST-A near piston, and then remove the ST-A from rack.
