9-2X F4-2.0L Turbo (2005)
(1) Flat (top side)
(2) Identification paint
(3) Inclined (bottom side)
Set the coil spring correctly so that its end face fits well into the spring seat as shown in the figure.
(1) Coil spring end face
Install the helper and dust cover to the piston rod.
Pull the piston rod fully upward, and install the rubber seat and spring seat.
Note: Ensure that the upper spring seat is positioned as shown in the figure.
(1) Outside of body
Install the strut mount to the piston rod, and then tighten a new self-locking nut temporarily.
Using a hexagon wrench to prevent strut rod from turning, tighten the self-locking nut with ST.
ST 32005223 STRUT MOUNT SOCKET
Tightening torque: 55 Nm (5.6 kgf-m, 41 ft. lbs.)
