9-2X F4-2.0L Turbo (2005)
8. Install center and rear exhaust pipes and muffler. (DOHC turbo model)
INSPECTION
Check the removed cable and replace if damaged, rusty, or malfunctioning.
1. Check for smooth operation of the cable.
2. Check the inner cable for damage and rust.
3. Check the outer cable for damage, bends, and cracks.
4. Check the boot for damage, cracks, and deterioration.
5. Move the select lever from "P" range to "1" range. You should be able to feel the detents in each range. If the detents cannot be felt or the range
pointer is improperly aligned, adjust the cable.
ADJUSTMENT
1. Set the vehicle on a lift.
2. Set the select lever to "N" range.
3. Lift-up the vehicle.
4. Remove the rear exhaust pipe and muffler.
^
SOHC model
^
DOHC turbo model
5. Loosen the adjusting nut on each side.
6. Turn the adjusting nut B until it lightly touches the connector.
7. While preventing the adjusting nut B from moving with a wrench, tighten the adjusting nut A.
