9-2X F4-2.0L Turbo (2005)
Shift Cable: Service and Repair
Reverse Check Cable
Reverse Check Cable
REMOVAL
1. Set the vehicle on a lift.
2. Remove the gear shift knob.
3. Remove the console box front.
4. Remove the spring pin from slider.
5. Remove the slider and spring.
6. Cut the band clip, and then separate the reverse check cable from gearshift lever.
7. Lift-up the vehicle.
8. Remove the under cover.
9. Remove the rear exhaust pipe and muffler.
10. Remove the crossmember.
11. Remove the snap pin and washer, and then separate the reverse check cable from reverse check lever.