9-2X F4-2.0L Turbo (2005)
Apply liquid gasket fully to three holes other than screw holes on transmission case.
Fluid packing: THREE BOND 1217B (Part No. 32005004)
Install the oil pan.
Tightening torque: 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)
fill ATF up to the middle of the COLD side on level gauge by using the gauge hole.
Check the ATF level.
ATF TEMPERATURE SENSOR
For installation of ATF temperature sensor, refer to Front Vehicle Speed Sensor.
Transfer Duty Solenoid And Valve Body
REMOVAL
Set the vehicle on a lift.
Disconnect the ground cable from battery.
Remove intercooler.
Remove the pitching stopper.
Remove center exhaust pipe.
Remove the rear exhaust pipe and muffler.
Raise the vehicle and drain the ATF.
