9-2X F4-2.0L Turbo (2005)
Clutch Disc: Service and Repair
Clutch Disc And Cover
REMOVAL
Remove the transmission assembly from vehicle body.
Install the ST on flywheel.
ST 32005146 CLUTCH DISC GUIDE
(A) Clutch cover
Remove the clutch cover and clutch disc.
Note:
^
Take care not to allow oil on the clutch disc facing.
^
Do not disassemble either the clutch cover or clutch disc.
^
Be sure to put alignment marks on the flywheel and clutch cover before removing clutch cover.
INSTALLATION
Insert the ST into clutch disc and install them on the flywheel by inserting the ST end into pilot bearing.
Note: When installing the clutch disc, be careful to its direction.
ST 32005146 CLUTCH DISC GUIDE
(A) Flywheel side
Install the clutch cover on flywheel and tighten the bolts to specified torque.
Note:
^
When reinstalling, align the alignment marks.
^
When installing a new clutch cover, position the clutch cover so that there is a gap of 120° or more between "0" marks on the flywheel and
clutch cover. ("0" marks indicate the directions of residual unbalance.)
^
Note the front and rear of the clutch disc when installing.
^
Tighten the clutch cover installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross order.
