9-2X F4-2.0L Turbo (2005)
INSTALLATION
EXCEPT STI MODEL
NOTE:
Before or during assembling, lubricate the following points with a light coat of grease.
^
Contact surface of lever and pivot
^
Contact surface of lever and bearing
^
Transmission main shaft spline (Use grease containing molybdenum disulphide.)
1. While pushing the release lever to pivot and twisting it to both sides, fit the lever spring onto the constricted portion of pivot.
NOTE:
^
Apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of release lever and operating cylinder.
^
Confirm that the lever spring is securely fitted by observing it through the main case hole.
2. Install the release bearing and fasten it with two clips. (Non-turbo model)
3. Install the release bearing. (Turbo model)
4. Install the dust cover.
5. Check smooth movement of the bearing with operating release lever.
6. Install the transmission assembly.
ST1 MODEL
1. Install the release bearing on transmission.
2. Insert the release fork into release bearing tab.
