9-2X F4-2.0L Turbo (2005)
Align the matching marks, and then connect the flange yoke and rear differential.
Tightening torque: 31 Nm (3.2 kgf-m, 22.9 ft. lbs.)
(A) Matching mark
Using new bolts, install the differential mount front cover.
Temporarily tighten the bolt (A) while pushing cover forward.
Tighten the bolt (B) to specified torque.
Tighten the bolt (A) to specified torque.
Tighten the remaining bolts to specified torque.
Tightening torque: 90 Nm (9.2 kgf-m, 66 ft. lbs.)
Install the center exhaust pipes.
Install the rear exhaust pipe and muffler.
INSPECTION
Note: Do not disassemble the propeller shaft. Check the following and replace if necessary.
Tube surfaces for dents or cracks
Splines for deformation or abnormal wear