9-2X F4-2.5L (2006)
(1) Rear sensor harness
(2) Trailing link
Check the ABS wheel speed sensor gap. After standard clearance is obtained, tighten the ABS wheel speed sensor on back plate to specified torque.
If the clearance is outside specification, readjust using spacer (Part No. 32009555).
ABS wheel speed sensor standard clearance: 0.7 - 1.2 mm (0.028 - 0.047 inch)
Tightening torque: 33 Nm (3.3 kgf-m, 24 ft. lbs.)
Note: Check the marks on the harness and make sure no kink exists. (RH: Light blue, LH: Brown)
After confirmation of the ABS wheel speed sensor clearance, connect the connector to ABS wheel speed sensor.
Connect the battery ground cable to battery.
INSPECTION
ABS WHEEL SPEED SENSOR
Check the pole piece of ABS wheel speed sensor for foreign particles or damage. If necessary, clean the pole piece or replace ABS wheel speed
sensor.
Measure the ABS wheel speed sensor resistance.
If resistance is out of standard value, replace the ABS wheel speed sensor with a new one.
Note: Check the ABS wheel speed sensor cable for discontinuity. If necessary, replace with a new one.
SENSOR GAP
Measure the clearance between tone wheel and ABS wheel speed sensor at whole periphery.
Note: If clearance is narrow, adjust by using spacer (Part No. 32009555).
If clearance is wide, check the outputted voltage then replace the ABS wheel speed sensor or tone wheel if the outputted voltage is outside
specification.
ABS wheel speed sensor clearance: 0.7 - 1.2 mm (0.028 - 0.047 inch)
