9-2X F4-2.5L (2006)
Compression Check: Testing and Inspection
Compression
Inspection
Important: After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.
1. After warming-up the engine, turn the ignition switch to OFF.
2. Make sure that the battery is fully charged.
3. Release the fuel pressure.
4. Remove all the spark plugs.
5. Fully open the throttle valve.
6. Check the starter motor for satisfactory performance and operation.
7. Hold the compression gauge tight against the spark plug hole.
NOTE: When using a screw-in type compression gauge, the screw (put into cylinder head spark plug hole) should be less than 18 mm (0.71
inch) long.
C8. rank the engine by means of the starter motor, and read the maximum value on the gauge when the pointer is steady.
9. Perform at least two measurements per cylinder, and make sure that the values are correct.
Compression (350 rpm and fully open throttle):
Standard: .................................................................................................................................... 1,020 - 1,275 kPa (10.4 - 13.0 kgf/cm2, 148 - 185 psi)
Difference between cylinders: .................................................................................................................................... 49 kPa (0.5 kgf/cm2, 7 psi) or less
