9-2X F4-2.5L (2006)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod end
Install the front stabilizer to vehicle.
Install the front exhaust pipe assembly.
Install the sub frame.
Install the under cover.
Align the center of roll connector.
Install the steering wheel.
Install the front wheels.
Tighten the wheel nuts to specified torque.
Tightening torque: 90 Nm (9.1 kgf-m, 65.8 ft. lbs.)
Connect the battery ground cable to battery.
Pour fluid into the oil tank, and bleed air.
Check for fluid leaks.
Install the jack-up plate.
Lower the vehicle.
Check the fluid level in oil tank.
After adjusting the toe-in and steering angle, tighten the lock nut on tie-rod end.
Tightening torque: 83 Nm (8.5 kgf-m, 61.5 ft. lbs.)
Note: When adjusting the toe-in, hold boot as shown to prevent it from being rotated or twisted. If twisted, straighten it.
