9-2X F4-2.5L (2006)
8. Install the rear exhaust pipe and muffler.
9. Install the console box.
INSPECTION
1. Verify whether the slider moves smoothly. If not, adjust the reverse check cable or check damage of slider.
2. Check that the gear can be shift to reverse, when the slider is pulled up. If the gear can not be shift to reverse, adjust the reverse check cable.
3. Check that the gear can not be shift to reverse, when the slider is not pulled up. If the gear can be shift to reverse, adjust or replace the reverse
check cable.
ADJUSTMENT
1. Set the vehicle on a lift.
2. Remove the under cover.
3. Remove the rear exhaust pipe and muffler.
4. Remove the crossmember.
5. Remove the snap pin and washer, and then separate the reverse check cable from reverse check lever.
6. Move the transmission to right side, and then remove the stay bolt and reverse check cable.
NOTE:
If the transmission is not moved, the stay bolt will contact body and damage may occur.
