9-2X F4-2.5L (2006)
Transmission Position Switch/Sensor: Service and Repair
Inhibitor Switch
Inhibitor Switch
INSPECTION
When the driving condition or starter motor operation is erroneous, first check the shift linkage for improper operation. If the shift linkage is
functioning properly, check the inhibitor switch.
1. Disconnect the inhibitor switch connector.
2. Check continuity in inhibitor switch circuits with the select lever moved to each position.
NOTE:
^
Also check that continuity in ignition circuit does not exist when the select lever is in "R", "D", "3", "2" and "1" ranges.
^
If the inhibitor switch is inoperative, check for poor contact of connector on transmission side.
3. Check if there is continuity at equal points when the select lever is tilted 1.5° in both directions from "N" range.
If there is continuity in one direction and the continuity in the other or if there is continuity at unequal points, adjust the inhibitor switch.
4. Repeat the above checks. If there are abnormalities, adjust the select cable.
REMOVAL
1. Set up the vehicle on a lift.
2. Move the select lever to "N" range.
3. Remove the air intake chamber (Non-turbo model).
4. Remove the intercooler. (Turbo model)
