9-3 (9440) L4-2.0L Turbo (2007)
/l4-2.0l_turbo/Page-2689014.png)
7. Fit the brake hose and the clip.
8. Remove the wedge and attach the ball joint to the steering swivel member with a nut and bolt. The pin must be visible above the steering swivel
member before the bolt is fitted. Tighten the nut.
Warning
Press up the pin carefully.
The groove in the pin must be visible in the screw hole in the spindle housing.
If the rubber gaiter is pressed down, it will not seal properly to the swivel pin.
Tightening torque 50 Nm (37 ft. lbs.)
9. Fit the right-hand air shield.
10. Fit the wheel arch liner.