9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-3055043.png)
EHU
Supplement D3
Replacing the Communication Unit (CU)
Important
Handle the fibre optic cables with care or the signal may be distorted.
^
It is very important that the two leads in the connector are not confused with one another.
^
Do not splice the cables.
^
Do not bend the cable in a radius smaller than 25 mm.
^
Do not expose the cable to temperatures exceeding 85 °C.
^
Keep the cable ends free from dirt and grime.
^
Do not expose the cable to impact as this may cause the transparent plastic to whiten, thereby reducing the intensity of the light and causing
possible communication interruptions.
^
The cable should not lie against any sharp edges as this may cause increased signal reduction.
Warning
The visible red light is laser class 1. Do not look directly into the optical fibre or the control module connector at a close distance. Distances of less
than 20 m between eye and light source can result in damage to the eye.
1.
Fold down the back rest in the rear seat.
