9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
18.
Fit the driver's seat in accordance with WIS "Body - Seats - Adjustment/Replacement - Front seat".
Marking the modification identity plate
After carrying out the procedure, box B1 on the modification identity plate must be marked. From and including M04, and for certain markets, there is
the table "Table of Modifications" in the car's Warranty and Service Book. Mark the box with the number "7" if the procedure was carried out by the
importer or with the number "8" if carried out by the dealer.
Fitting the modification identity plate M04
Note
A modification identity plate must only be fitted where local directives require the marking of the car.
1.
Open the boot lid and lift up the floor panel.
2.
Clean the body surface location for the plate with Teroson FL T875. Remove the protective plastic backing from the plate.