9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-2496005.png)
Note: Leads with 0.35 mm™ are doubled over and crimped together at both ends.
6.4. Place the shrink tube over the sleeve.
6.5. Heat the shrink tube until it is secured.
7. Strip 4 mm of the lead's insulation.
8. Search for the connector in the spare parts catalogue/EPC to find the part number of the pin to be used.
9. Fit the pin on the lead using olive green pliers (0.35-0.75 mm™) from 86 12 939 Toolbox, wiring harness.
10. Check that the stripped lead goes through the entire clamped portion of the pin and that the insulation is properly clamped.
11. Press the pin into the connector.
12. Check that the pin is properly secured.
13. Check that the connector pins are straight.
