9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-2409004.png)
3. Undo the pin catch by pressing in the extraction tool (part no. 85 80 151).
4. Pull out the cable with the pin.
5. Cut of the lead at the pin.
Note: For further information on how pins/sleeves are fitted, see Wiring harness repair.
6. If the lead is not long enough, splice it as follows:
6.1. Strip the insulation off of the leads.
6.2. Fit a shrink tube with adhesive on the line.
6.3. Fit sleeve (0.5-1.0 mm), using the blue pliers from 86 12 939 Toolbox, wiring harness.
