9-3 (9440) L4-2.0L Turbo (2.0 HOT) (2003)
/l4-2.0l_turbo_(2.0_hot)/Page-1973002.png)
1. Fit the boot onto the drive shaft.
2. Fit the drive shaft into the inboard drive shaft universal joint. Check first that the circlip is in the groove.
3. Press in the shaft until the circlip snaps in place. Use a hydraulic press.
4. Fill with 185g 87 92 798 Drive shaft grease, man. Save any excess to fill the boot later.
5. Fit the boot and apply the large clamp rings. Use a pair of 30 16 235 Pliers.
Important: A groove should be visible on the shaft.
