9-3 (9440) L4-2.0L Turbo (2.0 T) (2006)
/l4-2.0l_turbo_(2.0_t)/Page-3191004.png)
Keypad 12 781 997 without symbols for electrically heated seats:
-
On buttons both with and without symbols only the links between the frame and the buttons are to be cut off. Other pins on the sides and on the
rear are to remain.
-
On buttons without symbols, no pin is to be cut off as these are to be fixed dummy buttons.
8. Compare with the removed original buttons. Place the new buttons, which are to be cut, so that they cannot be positioned incorrectly when fitted
on the ACC panel. Make sure they are not mixed together with the old buttons which are to be discarded.
9. Cut off the links between the frame and the buttons. Start by cutting off the buttons using wire cutters. Then use a modelling knife to fine trim the
buttons. Note that on the frame with buttons for the electrically heated seats, the outside and the top side of the buttons are to be fine trimmed (the
pins that have not been links to the frame). This must not be performed on the buttons without symbols.
Cutting point for symbol with electrically heated seats:
Cutting point for symbol without electrically heated seats:
