9-3 (9440) L4-2.0L Turbo (2.0 T) (2006)
/l4-2.0l_turbo_(2.0_t)/Page-1169005.png)
2. Position the 83 96 202 Fitting tools, front crankshaft seal B207 protective collar on the crankshaft. Lubricate the new sealing ring with non-acidic
Vaseline and position it on the fitting tool.
3. Position the fitting tool on the crankshaft. Screw in the sealing ring using the crankshaft pulley bolt so that it is flush with the timing cover.
Remove the tool.
4. Fit the crankshaft pulley with a new bolt. Use 83 95 360 Holding tool, crankshaft pulley (shaft only) and 83 96 210 Holding tool, crankshaft
pulley, B207. Hold the engine down slightly with a bracket to gain access to the bolt. Bend the plate back and spray 30 15 948 Cavity fluid to
prevent rust damage.
Tightening torque 100 Nm + 75 degrees (74 ft. lbs. + 75 degrees)
