9-3 (9440) L4-2.0L Turbo (2.0 T) (2006)
/l4-2.0l_turbo_(2.0_t)/Page-1561014.png)
NOTE: For further information on how pins/sleeves are fitted, see Wiring harness repair.
6. If the lead is not long enough, splice it as follows:
6.1. Strip the insulation off of the leads.
6.2. Fit a shrink tube with adhesive on the line.
6.3. Fit sleeve (0.5-1.0 sq.mm), using the blue pliers from 86 12 939 Tool box, wiring harness.
NOTE: Leads with 0.35 sq.mm are doubled over and crimped together at both ends.
6.4. Place the shrink tube over the sleeve.
6.5. Heat the shrink tube until it is secured.
7. Strip 4 mm of the lead's insulation.
8. Search for the connector in the spare parts catalogue/EPC to find the part number of the sleeve to be used.
9. Fit the sleeve on the lead using olive green pliers (0.35-0.75 sq.mm) from 86 12 939 Tool box, wiring harness.
10. Check that the stripped lead goes through the entire clamped portion of the sleeve and that the insulation is properly clamped.
