9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-4066001.png)
Convertible Top Hydraulic Hose: Service and Repair
Hydraulic Lines
Hydraulic Lines
Removing
The following is a description of changing the hydraulic lines on the hydraulic unit only. Changing hydraulic lines to the hydraulic cylinder is illustrated
in the instructions for the respective hydraulic cylinder. See Soft top cover hydraulic cylinder, Hydraulic cylinders for locking first bow, Soft top
hydraulic cylinder or Sixth bow hydraulic cylinder.
It is not always necessary to dismantle the entire hydraulic cylinder when changing its hydraulic lines.
1. Close the soft top completely.
2. Remove Luggage compartment side trim, CV.
3. Undo the nuts to the hydraulic unit and lift it out somewhat to access the connections.
IMPORTANT: Lift up the hydraulic unit carefully so that the hydraulic hoses are not damaged.
4. Place some paper under the hydraulic unit to catch any hydraulic fluid that may run out.
5. Remove the bolts for the hydraulic hose attaching plate.
