9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-4077002.png)
5. Place some paper under the hydraulic unit to catch any hydraulic fluid that may run out.
6. Remove the pump motor bolts.
7. Remove the pump motor from the hydraulic unit.
IMPORTANT: The hydraulic unit must be standing straight up with the oil reservoir at the bottom while the pump motor is being
removed so that oil does not run out. It may be necessary to remove some cable ties in order to hold the oil reservoir at the bottom.
8. Remove the drive clutch from the motor.
