9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-4274010.png)
6. Lift up the template and fit pieces of tape where the holes are to be drilled (x 5).
7. Reposition the template and affix it with tape.
IMPORTANT: Check the position of the template and adjust as necessary.
8. Drill holes in accordance with the markings.
IMPORTANT: Do not use a centre punch to mark the positions of the holes. Do not press the drill against the boot lid while drilling.
Drill with a 2 mm bit first, then a 5 mm bit and finally a 7 mm bit.
9. Remove the template and the pieces of tape.
10. Deburr the holes and remove loose filings and flakes of paint. Clean using Teroson FL cleaning agent. Apply Standox 1K Primer Filler. Apply the
top coat. Apply Terotex HV 400 cavity sealant on internal surfaces.
11. Fit the enclosed pieces of zinc tape to the boot lid.
12. Fit the weatherstrip inside the lower edge of the spoiler in the following way:
^
Farthest out on each side.
^
Along the front edge of the spoiler between the outer bolts.
^
Along the rear edge of the spoiler between the outer bolts.
