9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-2468002.png)
^
Connect the brake bleeder (A) to the air nipple on the brake caliper for the left-hand front wheel.
^
Open the nipple and draw out brake fluid until one of the reservoir chambers is empty.
^
Close the nipple and disconnect the brake bleeder.
Tightening torque for air nipple: 16 Nm (12 ft. lbs.)
^
Connect the brake bleeder to the air nipple on the front right wheel.
^
Open the nipple and draw out brake fluid until the other reservoir chamber is empty.
^
Close the nipple and disconnect the brake bleeder.
Tightening torque for air nipple: 16 Nm (12 ft. lbs.)
^
Lower the car.
8. Manual gearbox: Drain the brake fluid reservoir's clutch chamber:
^
Connect the brake bleeder to the clutch bleed nipple.
^
Open the nipple and suction out brake fluid until the level in the reservoir falls below the connection.
^
Close the nipple and disconnect the brake bleeder.
^
Remove the hose for the clutch from the brake fluid reservoir.
9. Unplug the connector (A) for the brake fluid reservoir's level sensor.
