9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-1363004.png)
6. Remove the sensor (B).
To fit
1. Fit the sensor (B) using a new O-ring lightly coated with acid-free Vaseline.
Tightening torque 10 Nm (7 ft. lbs.)
IMPORTANT: Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further
information regarding connectors, refer to Connectors, handling and inspection.
2. Plug in the crankshaft position sensor connector (A).
3. Fit the heat shield (C).
