9-3 (9440) V6-2.8L Turbo (2008)
Engine Control Module: Removal and Replacement
Control Module, Motronic E9, V6 Petrol (608)
To remove
1. Carry out procedure before removing control module.
IMPORTANT: It is important to follow the order in Tech2 as some data is loaded into the new control module.
2. Move the ignition key to the LOCK position.
3. Remove the upper engine cover.
4. Detach the ground cables from the control module.
5. Carefully press down the catches and carefully unplug the connectors from the control module one at a time so that the connection pins are not
damaged.
IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves
straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection.
6. Remove the control module.