9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-278002.png)
3. Remove the front part of the air duct.
Important: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight
apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection.
4. Unplug the control module connector and the upper ribbon cable and disconnect the solenoid cable.
5. Release the catch with a screwdriver and remove the control module by pulling it forward.
To fit
1. Fit the control module.
