9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-3167004.png)
4. Fit Headlining, 5D.
5. Connect the battery.
6. Turn ON the ignition switch and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check whether a diagnostic trouble code is shown:
If a diagnostic trouble code is shown:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If a diagnostic trouble code is not shown:
The assembly was successful. Disconnect the diagnostic tool.
7. Carry out Measures after disconnecting the battery.
