9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-399034.png)
3. Connect the position sensor cable connector.
4. Fit the cable tie to the position sensor.
Important: Cables to hydraulic lines and position sensors must be refitted as they were earlier or there will be a risk of them being
damaged when the soft top and soft top cover are operated.
5. Remove the soft top support and raise the soft top.
6. Test the operation of the soft top.
7. Connect the diagnostics tool and erase any diagnostic trouble code.
Position Sensor, Soft Top Cover Open (562o)
Position Sensor, Soft Top Cover Open (562o)
To remove
Only the soft top cover hydraulic cylinder, mounted on the right-hand side of the car, is equipped with a position sensor.
1. Open the soft top cover. Raise the sixth bow and support it with 82 93 847 Soft top support.
