9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-837002.png)
Tightening torque 9 Nm (7 lbf ft)
2. Connect the impact sensor's connector.
3. Fit the front bumper casing.
4. Connect the battery.
5. Turn ON the ignition and check the airbag system and control module using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any diagnostic trouble codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check whether a diagnostic trouble code is displayed:
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostics instrument.
6. Carry out Measures after disconnecting the battery.
