9-3 (9440) V6-2.8L Turbo (2008)
Impact Sensor: Service and Repair
Impact Sensor, Side (328D, 328P), CV
Impact Sensor, Side (328D, 328P), CV
WARNING: Read through Safety and handling instructions and Before removing a control module before starting work.
To remove
WARNING: The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery
before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe
personal injuries.
1. Remove the rear seat cushion.
2. Turn the ignition key to the LOCK position.
3. Set the seat to its front position.
4. Remove the inner sill trim.
5. Fold under the carpet.
6. Remove the protective plate.
7. Release the screws a few turns, press the locking clip together on the rear of the side impact sensor. Press the front of the side impact sensor back
and lift out the sensor.