9-3 (9440) V6-2.8L Turbo (2008)
2. Fit in the wiring harness (B).
^
Make sure that the connector's guide pin locates in the groove and fit the circlip (A).
3. Fit the control module.
Important: Counterhold the locking sector when the control module and lever are fitted.
^
Carefully press the control module straight and down towards the shaft and the connector.
^
Fit the control module screws (D).
Tightening torque: 25 Nm (18 ft. lbs.)
^
Pull the gear cable sleeve (C) backwards and fit the cable in its bracket.