9-3 (9440) V6-2.8L Turbo (2008)
1. Clean the anti-roll bar and grease the inside of the bushes with 30 20 476 Ball bearing grease. Fit the bushes to the anti-roll bar and fit the caps.
2. Fit the anti-roll bar to the subframe.
Tightening torque bolt 8.8 (flange diameter 15.2 mm): 18 Nm (13 ft. lbs.) and use Thread locking adhesive, Loctite 242
Tightening torque bolt 10.9 (flange diameter 16.7 mm): 31 Nm (23 ft. lbs.)
3. Fit the anti-roll bar link to the steering swivel member on both sides.
Tightening torque 53 Nm (39 ft. lbs.)
4. Lower the car to the floor.
Rear Anti-Roll Bar Bush, 4WD
Rear anti-roll bar bush, 4WD