9-3 (9440) V6-2.8L Turbo (2008)
directives require the marking of the car. If the box is not marked, continue as follows.
Procedure, cars with mileage below 15 000 km
1.
Raise the car.
2.
Inspect the area around the drive shaft seal.
Is there any leakage?
Yes: Proceed to step 3.
No: Proceed to step 4.
3.
Replace the drive shaft and drive shaft seal. See WIS 9-3 (9440) - 4. Power transmission - Drive shafts - Drive shafts, rear, 4WD as well as WIS
9-3 (9440) - 4. Power transmission - Drive shafts - Drive shaft seal, rear, 4WD.
Replaced material is returned in accordance information shown above.