9-3 (9440) V6-2.8L Turbo (2008)
/v6-2.8l_turbo/Page-4886023.png)
2. Lift up the clip with the tool and place a knife underneath. Pull out the clip with the tool, following after with the knife to protect the window
frame.
3. Continue in the same manner with the remaining clips.
4. Lift away the window and change the outer roof, rear window or rear window seal as necessary.
Assembling The Outer Roof And Rear Window
NOTE: Change or touch up the window frame if it is damaged.
1. Fit the rear window seal. Make sure the joint in the seal is located in the middle at the top of the rear window.
2. Lay the rear window in the outer roof frame and put the loose frame on top.
3. Secure the frame and outer roof to the centre marking of the respective part.
4. Fit the clip on each side. Use 30 12 598 Circlip pliers and open the clip. Insert the clips at the locations marked on the frame.
WARNING: Use protective goggles as the clip can fly off the pliers.
Do not press the clips fully onto the frames before the headlining has been fitted on the inner frame.
