9-3 Arc/Aero (9440) L4-2.0L Turbo (2.0 T) (2004)
/l4-2.0l_turbo_(2.0_t)/Page-3901004.png)
^
**3X
3.
Yes: Proceed to Step 4.
No: The seat is not affected and must not be replaced. Proceed to step 6.
4.
Is there white marking by the production code?
Yes: The seat is not affected and must not be replaced. Proceed to step 6.
No: Proceed to step 5.
5.
Do the 3 first characters correspond to any of the combinations in the following list?
^
FN3**
^
GN3**
^
IN3**
^
JN3**
Yes: The seat is not affected and must not be replaced. Proceed to step 6.
No: The seat must be replaced. Order a new seat and replace the seat in accordance with the method in WIS, see 9-3 (9440) 2004 - Body -
Seats - Adjustment/Replacement - Front seat, CV.
Use 74 96 268 Thread lock on the seat bolts.
Important
Replaced seats must be scrapped. The enclosed instruction "Scrapping seats" should be followed when scrapping the seats.
Then proceed to step 6.
6.
Carry out the check on the other seat.
Warranty/Time Information
See separate information.
Scrapping seats
Warning
The following points must be followed unconditionally when working on the airbag system:
^
All work must take place in accordance with the instructions given and carried out with caution. Risk of personal injury exists in the event of
incorrect handling.
^
Ear defenders must be worn when deploying the airbag and belt tensioner.
^
The airbags should be kept at room temperature. At temperatures above +115° C (239°F) there is a risk of self-deployment.
^
The belt tensioners should never be exposed to temperatures above +100°C (212°F).
^
The airbags must be kept in a special area, separate from storage areas for petroleum products or other inflammable materials.
^
Wear protective glasses and protective gloves when dismantling deployed airbags. Place the airbag in a fully sealing plastic bag. Wash your hands
using a mild soap solution and lukewarm water after working with a deployed airbag.
^
The airbags and belt tensioner are classified as pyrotechnic articles and must be stored and handled in accordance with the laws and provisions in
each country.
^
The belt tensioner must not be treated with grease, cleaning agents or similar.
The following tools should be used when scrapping the seat
